Simulation and Performance Test Giromill Type Wind Turbine; Case Study Muara Enim, South Sumatra, Indonesia
DOI:
https://doi.org/10.53893/ijrvocas.v1i2.10Keywords:
Wind energy, Giromill, Simulation, Performance Test, Muara EnimAbstract
This research examines the dynamic load resistance of the Giromill type wind turbine to the variable wind speed, which is converted to the value of the force received by the wind turbine blades. The analysis was carried out numerically using Autodesk Inventor Professional 2019 software. The variations in wind speed used were 2.5 m/s with a force value of 0.195 N for the Giromill turbine, at a speed of 3.5 m/s with a force value of 0.274 N, at 4.5 m /s with a Force value of 0.352 N and a wind speed of 5.5 m/s with a force rating of 0.430 N. From the simulation results using the Autodesk Inventor Pro 2019 software, the effect of gravitational force is greater than the wind force in, so stress analysis is mainly caused by gravity while the wind force has no significant impact. The simulation results also have a characteristic that the higher the wind speed, the lower the stress value. In addition to the dynamic load simulation, the author also tries to implement the Giromill wind turbines in Muara Enim district, South Sumatra, Indonesia. The wind turbine blade rotation will be faster, and the Wind Generator will produce a greater voltage if it is supported by sufficient wind speed.
References
Institute for Essential Service Reform, “Buletin Strategic Partnership Green and Inclusive Energy,” Jakarta, November 2019.
Sekretariat Jenderal Dewan Energi Nasional, “Ketahanan Energi Indonesia,” Dewan Energi Nasional,Jakarta, 2019. (in Indonesian).
Sekretariat Jenderal Dewan Energi Nasional, ISSN 2527 3000, “Outlook Energi Indonesia 2019,” Dewan Energi Nasional,Jakarta, 2019. (in Indonesian).
R. Ploetz, R. Rusdianasari, E. Eviliana, ”Renewable Energy: Advantages and Disadvantages,” Proceeding Forum in Research, Science, and Technology (FIRST), 2016.
Y Bow, T Dewi, A Taqwa, Rusdianasari, Zulkarnain, “Power Transistor 2N3055 as a Solar Cell Device,” International Conference on Electrical Engineering and Computer Science (ICECOS), IEEE, 2018.
Kurniawan A, Taqwa A, Bow Y, “PLC Application as an Automatic Transfer Switch for on-grid PV System; Case Study Jakabaring Solar Power Plant Palembang,” J. Phys.: Conf. Ser. 1167 012026, 2019.
S Widodo, A Taqwa and R Rusdianasari, “Solar panels output optimization using Phase Change Material (PCM) and heatsink applied in open-pit mining,” IOP Conf. Series: Materials Science and Engineering 1073 (2021) 012041, 2021.
Mirdiansyah, A. Taqwa, Y. Bow. “Monitoring Depth of Discharge of a Valve Regulated Lead Acid Battery in a Standalone PV System,” Proceedings of the 4th Forum in Research, Science, and Technology (FIRST-T1-T2-2020), 2021.
Trevor M.Letcher, “Wind Energy Engineering,” A Handbook for Onshore and Offshore Wind Turbines. Elsevier, 2017.
Bhutta, M.M.A., Hayat, N., Farooq, A. U., Ali, Z., Jamil, Sh. R., Hussain, Z, “Vertical Axis Wind Turbine- A Review of Various Confiugations and Design Techniques” Elsevier Ltd. 2011
Dwiyantoro, B. A., Suphandani V., Rahman, “Studi Eksperimental tentang Karakteristik Turbin Angin Sumbu Vertikal Jenis Darrieus – Savonius,” Proceeding Seminar Nasional Tahunan Teknik Mesin XIV (SNTTMXIV), 2015. (in Indonesian)
A. Taqwa, R. Rusdianasari, Budiman, RD. Kusumanto, T. Dewi, “Synchronization and application of IoT for on grid hybrid PV-wind system,” International Conference on Applied Science and Technology (iCAST) IEEE 617-621, 2018.
Melda Latif, “Efisiensi Prototipe Turbin Angin Savonius pada Kecepatan Angin Rendah,” Universitas Andalas Padang. Jurnal Rekayasa Elektrika, 2013. (in Indonesian).
Sathyajith Mathew, “Wind Energy Fundamental, Resource Analisys and Economic,” Faculty of Engineering. KCAET. Tavanur India. 2006.
Hau, Erich, “Wind Turbines Fundamentals, Technologies, Application, Economics,” Springer. Germany. 2006.
Iqbal Pandu Prakoso, P.Hartono,U.Lesmana, “Perencanaan Turbin Angin Sumbu Vertikal Tipe Darrieus-H dengan penambahan 2 Blade Savonius untuk Pembangkit Listrik” FTUIM (in Indonesian)
R. B. Yuliandi, R. Rusdianasari, T. Dewi, “Comparison of blade dimension design of a vertical wind turbine applied in low wind speed,” In proceeding of E3S Web of Conference EDP Science, Vol. 68, 2018.
R. Gupta, A. Biswas, K.K. Sharma, “Comparative study of a three-bucket Savonius rotor with a combined three-bucket Savonius – three-bladed Darrieus rotor,” Renewable Energy 33 , 2008.
C. Sovanara, F. Firdaus, R. Rusdianasari, “A Review on environmental impact of wind energy,” in Proceeding Forum in Research, Science, and Technology (FIRST), 2016.
R. H. Barnes, E. V Morozov, and K. Shankar, “Improved Methodology For Design Of Low Wind Speed Specific Wind Turbine Blades,” Compos. Struct., vol. 119, pp. 677–684, 2015.
Kalantar M, Mousavi GSM, “Dynamic behavior of a stand-alone hybrid power generation system of wind turbine, microturbine,” solar array and battery storage. Appl Energy 2010;87:3051–64.
J. Yen and N. Ahmed, “Improving Safety And Performance Of Small-Scale Vertical Axis Wind Turbines,” Procedia Eng., vol. 49, pp. 99–106, 2012
Chong, W.T., et al., “Exhaust Air Energy Recovery System for Electrical Power Generation in Future Green Cities,” International Journal of Precision Engineering and Manufacturing, 14(6): p. 1029-1035, 2013.
M.H. Mohamed, A.M. Ali, A.A. Hafiz, “CFD Analysis For H-Rotor Darrieus Turbine As A Low Speed Wind Energy Converter”, Engineering Science and Technology, an International Journal 18 ,2015.
R.Hassanzadeh, M. Mohammadnejad., "Effects of inward and outward overlap ratios on the two-blade Savonius type of vertical axis wind turbine performance". International Journal of Green Energy, 2019.
Additional Files
Published
How to Cite
Issue
Section
License
Copyright (c) 2021 Ovi Irawan, Yohandri Bow, RD Kusumanto

This work is licensed under a Creative Commons Attribution 4.0 International License.
All articles published in International Journal of Research in Vocational Studies (IJRVOCAS) are distributed under the Creative Commons Attribution 4.0 International License (CC BY 4.0).
Under this license, users are permitted to share, copy, redistribute, adapt, transform, and build upon the published work for any purpose, including commercial use, provided that appropriate credit is given to the original authors and IJRVOCAS, a link to the license is provided, and any changes made are indicated.
Authors retain the copyright of their published articles and grant IJRVOCAS the right of first publication. The journal makes published articles freely and permanently available online immediately upon publication.
Proper attribution should include the author names, article title, journal title, publication year, volume, issue, page numbers or article number where applicable, DOI or URL, and a reference to the CC BY 4.0 license.
The full terms of the Creative Commons Attribution 4.0 International License are available at:
https://creativecommons.org/licenses/by/4.0/
By submitting a manuscript to IJRVOCAS, authors agree that accepted articles will be published under the CC BY 4.0 license.











