Hybrid Passive Cooling System for Rooftop Photovoltaics with Varying Height Clearances
DOI:
https://doi.org/10.53893/ijrvocas.v5i2.428Keywords:
Hybrid, Photovoltaic, Height, Passive Cooling, Peltier, Thermoelectric GeneratorAbstract
The increasing adoption of rooftop photovoltaic (PV) systems as a renewable energy source is often hindered by the negative impact of high operating temperatures on their efficiency. To address this, a hybrid passive cooling system offers a promising solution to enhance the power output of PV panels while supporting environmental sustainability. This study investigates the effects of varying the height clearance between a PV panel and the roof surface on the thermal performance and energy efficiency of a hybrid passive cooling system. The research integrates a passive cooling setup, which utilizes natural airflow without additional energy consumption, with a thermoelectric generator (TEG) based on a Peltier module to convert waste heat into supplementary electrical energy. The study employed both simulation and experimental methods to analyze the thermal and energy performance of the system at different height configurations. Five identical 30W Maysun solar panels were tested at heights of 1 cm, 5 cm, 10 cm, 15 cm, and 20 cm, with data on temperature and voltage collected throughout the day. The results indicate that increasing the installation height significantly improves air circulation, leading to lower panel temperatures and higher voltage outputs. The optimal configuration was found to be at a height of 20 cm, which consistently yielded the highest voltage. Furthermore, the integration of a Peltier module with a heatsink proved effective, generating up to 623 mV of additional voltage by converting waste heat. These findings provide valuable insights and practical recommendations for designing more efficient rooftop PV installations, contributing to the advancement of sustainable building technologies and the global effort to reduce carbon emissions.
References
A. Isella and D. Manca, “GHG Emissions by (Petro)Chemical Processes and Decarbonization Priorities—A Review,” Energies, Oct. 2022, doi: 10.3390/en15207560.
M. Abid, M. Kumar, V. K. P. Raj, and M. J. Dhas, “Environmental Impacts of the Solar Photovoltaic Systems in the Context of Globalization,” Ecological Engineering & Environmental Technology, Mar. 2023, doi: 10.12912/27197050/157168.
G. Martinopoulos, “Are rooftop photovoltaic systems a sustainable solution for Europe? A life cycle impact assessment and cost analysis,” Applied Energy, Jan. 2020, doi: 10.1016/J.APENERGY.2019.114035.
N. Bansal, V. K. Srivastava, and J. Kheraluwala, “Rooftop Solar Power Generation: An Opportunity to Reduce Greenhouse Gas Emissions,” Jan. 2019, doi: 10.1007/978-981-13-3272-2_10.
A. Albatayneh and R. Albadaineh, “The impact of PV panels on cooling and heating loads of residential buildings in a humid subtropical climate zone,” Energy Exploration & Exploitation, May 2023, doi: 10.1177/01445987231174770.
C. B. Honsberg, S. Bowden, I. R. Sellers, R. R. King, and S. M. Goodnick, “Photovoltaic Surfaces to Reverse Global Warming,” in 2022 IEEE 49th Photovoltaics Specialists Conference (PVSC), Feb. 2022. doi: 10.1109/pvsc48317.2022.9938772.
C. Zhou, W. Sun, M. Wang, J. Luo, and L. Liu, “A comparative investigation of the cooling effect of multi-layer arrangements of panels in a ground-mounted photovoltaic system,” Journal of Renewable and Sustainable Energy, Oct. 2021, doi: 10.1063/5.0058861.
M. Sharaf, M. Yousef, and A. S. Huzayyin, “Review of cooling techniques used to enhance the efficiency of photovoltaic power systems,” Environmental Science and Pollution Research, Jan. 2022, doi: 10.1007/s11356-022-18719-9.
N. Singh and Dr. V. N. Bartaria, “Thermal Effects on Photovoltaic Panel Efficiency and Enhanced Cooling Strategies for Optimal Performance,” Dec. 2023, doi: 10.55083/irjeas.2023.v11i04011.
G. Mittelman, A. Alshare, and J. H. Davidson, “A model and heat transfer correlation for rooftop integrated photovoltaics with a passive air cooling channel,” Solar Energy, Aug. 2009, doi: 10.1016/J.SOLENER.2009.01.015.
A. Cortes, Y. Murashita, T. Matsuo, A. Kondo, H. Shimadera, and Y. Inoue, “Numerical evaluation of the effect of photovoltaic cell installation on urban thermal environment,” Sustainable Cities and Society, Dec. 2015, doi: 10.1016/J.SCS.2015.07.012.
S. Wu and C. Xiong, “Passive cooling technology for photovoltaic panels for domestic houses,” International Journal of Low-carbon Technologies, Jun. 2014, doi: 10.1093/IJLCT/CTU013.
A. R. Amelia, M. Jusoh, and I. S. Idris, “Effect of Thermoelectric Cooling (TEC) module and the water flow heatsink on Photovoltaic (PV) panel performance,” Epj Web of Conferences, Nov. 2017, doi: 10.1051/EPJCONF/201716201077.
K. Pervez Amber, W. Akram, M. A. Bashir, M. S. Khan, and A. Kousar, “Experimental performance analysis of two different passive cooling techniques for solar photovoltaic installations,” Journal of Thermal Analysis and Calorimetry, Feb. 2021, doi: 10.1007/S10973-020-09883-6.
Z. Liu, Y. Shuang, Y. Yuan, G. Li, and Q. Wang, “A thermoelectric generator and water-cooling assisted high conversion efficiency polycrystalline silicon photovoltaic system,” Frontiers in energy, Jun. 2021, doi: 10.1007/S11708-020-0712-1.
S. Pandiaraj, A. A. Jaffar, S. Muthusamy, H. Panchal, and S. Pandiyan, “A study of solar heat gain variation in building applied photovoltaic buildings and its impact on environment and indoor air quality,” Energy Sources Part A-recovery Utilization and Environmental Effects, Jul. 2022, doi: 10.1080/15567036.2022.2096725.
S. U. A and S. A. Jumaat, “The Hybrid Photovoltaic-Thermoelectric Generator Configurations for Energy Performance Improvement,” International Journal of Integrated Engineering, Jun. 2022, doi: 10.30880/ijie.2022.14.03.001.
H. El Kharaz, K. Khallaki, M. S. Kadiri, and K. Choukairy, “Performance’s improvement methods of PV solar panel by different cooling systems: A review of experimental and numerical studies,” Apr. 2021. doi: 10.1063/5.0049573.
M. A. Elias, R. M. Jais, N. Muda, N. A. Azlin, and N. M. Ahmad, “Research on different types of cooling system on ground mounted solar photovoltaic system for electrical output enhancement,” Oct. 2021, doi: 10.1088/1742-6596/2051/1/012071.
M. Barrasso, G. Langella, A. Amoresano, and P. Iodice, “Latest Advances in Thermal Energy Storage for Solar Plants” Mar. 2023.
H. Kandry et al., “Optimized photovoltaic panels power using cooling system based thermoelectric materials,” Materials Today: Proceedings, Aug. 2022, doi: 10.1016/j.matpr.2022.07.381.
Z. Khalili and M. Sheikholeslami, “Investigation of innovative cooling system for photovoltaic solar unit in existence of thermoelectric layer utilizing hybrid nanomaterial and Y-shaped fins,” Sustainable Cities and Society, Mar. 2023, doi: 10.1016/j.scs.2023.104543.
S. Pathak, P. O. Sharma, V. Goel, S. Bhattacharyya, H. S. Aybar, and J. P. Meyer, “A detailed review on the performance of photovoltaic/thermal system using various cooling methods,” Sustainable Energy Technologies and Assessments, Jun. 2022, doi: 10.1016/j.seta.2021.101844.
E. P. Soderholm, E. Cotter, and D. McCloskey, “Enhancing Efficiency and Lifetime of Photovoltaic Systems Through Passive Convective Cooling,” in Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems, May 2022. doi: 10.1109/iTherm54085.2022.9899647.
M. Ghasemian, M. Sheikholeslami, and M. Dehghan, “Innovative cooling techniques used for performance enhancement of photovoltaic systems,” Waves in Random and Complex Media, Jun. 2023, doi: 10.1080/17455030.2023.2226232.
Additional Files
Published
How to Cite
Issue
Section
License
Copyright (c) 2025 Pebi Dian Fauzi, RD. Kusumanto, Abu Hasan

This work is licensed under a Creative Commons Attribution 4.0 International License.











